Replaceable Parts
TDS1000B and TDS2000B Series Oscilloscope Service Manual
8-- 3
Using the Replaceable Parts List
This section contains a list of the mechanical and/or electrical components that
are replaceable for the oscilloscope. Use this list to identify and order replace-
ment parts. The table below describes each column in the parts list.
Column Column name Description
1 Figure & Index Number Items in this section are referenced by figure and index numbers to the exploded view illustrations
that follow.
2 Tektronix Part Number Use this part number when ordering replacement parts from Tektronix.
3 and 4 Serial Number Column three indicates the serial number at which the part was first effective. Column four
indicates the serial number at which the part was discontinued. No entries indicates the part is
good for all serial numbers.
5 Qty This indicates the quantity of parts used.
6 Name & Description An item name is separated from the description by a colon (:). Because of space limitations, an
item name may sometimes appear as incomplete. Use the U.S. Federal Catalog handbook H6-1
for further item name identification.
Abbreviations conform to American National Standard ANSI Y1.1--1972.
Figures 8--1 through 8--4 show the module-level exploded views of the
TDS1000B and TDS2000B oscilloscopes. On the adjacent page is the list of
components for that exploded view, indexed by the numbers in the figure.
Abbreviations
Exploded Views
To Next Page
Loading...
Need help?
General
