Maintenance
6-- 8
TDS1000B and TDS2000B Series Oscilloscope Service Manual
Use the following tools to remove and replace all modules in the oscilloscope:
H Torque-limiting screwdriver, long shank, 12 in-lb (1.3 N
⋅m) range with
Torx® T-15 tip; if you use a magnetic screwdriver with interchangeable bits,
the T--15 bit must be a long bit, at least 5 cm (2 in) overall length
H Torque-limiting screwdriver with Torx T--8 bit
H 5/8 inch deep socket with wide center hole (S
⋅K Hand Tool Corp., S-K
#40820, or equivalent)
H Torque wrench to 40 in-lb (4.5 N
⋅m)
H Screwdriver with 1/4 inch flat blade
H Pliers (all-purpose and needle-nose)
H Sharp knife (X-ACTO
® knife or equivalent)
H 3M Electrical Tape 92 with 1--mil polyimide Kapton backing, temperature
rated 180 °C, UL510 Flame Retarded
You will need a flat-blade screwdriver to remove the rear feet.
Removal. To remove the rear feet, refer to Figure 8--4 and follow these steps:
1. Place the oscilloscope face down on a soft surface such as an anti-static mat.
2. Use a flat-blade screwdriver to pry out the foot, or twist the foot as you are
removing it so that it disengages from the guides. Use care not to mar the
surface of the rear case.
Installation. To install the rear feet, refer to Figure 8--4 and follow these steps:
1. Place the oscilloscope face down on a soft surface such as an anti-static mat.
2. Align the slots of the rear foot with the guides in the rear case and press the
foot in.
You will need a pair of needle-nose pliers to remove the flip feet.
Removal. To remove the flip feet, refer to Figure 8--4 and follow these steps:
1. Place the oscilloscope face down on a soft surface such as an anti-static mat.
2. Grip the flip foot with the pliers as close to the notches as possible and
squeeze gently on the foot.
3. Twist slightly to swing one hinge free of the slot.
Required Tools
Rear Feet
Flip Feet
To Next Page
Loading...
Need help?
General
