Appendix G: Ethernet Set up
TDS3000B Serie s User Manual
G-3
5. To verify that the network assigned an IP address to t he
oscilloscope, push the Change Instrument Settings side button
to display the oscilloscope ethernet settings. The instrument IP
address field should now be filled in.
If the instrument IP address field is blank, then the oscilloscope
was not able to obtain an IP address from the network. Contact
your network administrator for help, or use the proce dure on page
G-- 3 to manually enter the Ethernet settings.
Networks That Do Not Support DHCP and BOOTP
If your network does not support DHCP or BOOTP protocols, you
will need to manually enter the oscilloscope network settings. To
enter the Ethernet network settings information from section 1 of the
form, do the followi ng steps:
1. Push the UTILITY front panel button.
2. Push the System bottom button to select I/O.
3. Push the Ethernet Network Settings bottom button.
4. Push the Change Instrument Settings side button. The
oscilloscope displays the Instrument Setup screen.
5. Use the Instrument Setup screen menu items and controls to enter
the network settings information from section 1 of the form. See
page G--8 for a descri ption of the Instrument Setup screen.
6. If the form shows that DHCP or BOOTP are supported on your
network, push the DCHP/BOOTP side button to select On.
7. When you are done entering the Ethernet ne twork settings, push
the OK Accept side button to store the settings in your
instrument.
To Next Page
Loading...
Need help?
General
