Maintenance
TDS3000B Series Service Manual
6-27
You will need a Torx® T-10 screwdriver to remove the front chassis.
Removal. Use this procedure to remove the front chassis and the display module.
1. Place the oscilloscope face down on a soft surface (such as an anti-static
mat), with the bottom facing you.
2. Use the Torx® T-10 screwdriver to remove the two screws that secure the
front chassis to t he front case. See Figure 6--15.
Screws
T-10 (2)
Front chassis
Front panel assembly
Figure 6- 15: Front chassis
3. Lift the front chassis out of the front case. Lifting the left end of the chassis
slightly ahead of the right end helps to clear a slight interference at the right
end of the chassis.
Front Chassis and Display
Module
To Next Page
Loading...
Need help?
General
