Compliance information
Additional compliances
IEC 61010-1. Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 1: General
Requirements.
IEC 61010-2-030. Safety Requirements for Electrical Equipment
for M easurement, Control, and Laboratory Use – Part 2-030:
Particular requirements for testing and measuring circuits.
Equipment type
Test and measuring equipment.
Safety class
Class 1 – grounded product.
Pollution degree descriptions
A measure of the contaminants that could occur in the environment
around a nd within a product. Typically the internal environment inside
a product is considered to be the same as the external. Pro ducts should
be used only in the environment for which they are rated.
Pollution degree 1. No pollution or only dry, nonconductive
pollution occurs. Products in this category are generally
encapsulated, hermetically sealed, or located in clean rooms.
Pollution deg ree 2. Norm a ll y only dry, nonconductive pollution
occurs. Occasionally a temporary conductivity that is caused
by condensation must be expected. This location is a typical
office/home environm ent. Temporary condensatio n occurs only
when the product is out of service.
Pollution degree 3. Con ductive p ollution, o r dry, nonconductive
pollution that becomes conductive due to condensation. These
are sheltered locations where neither temperature nor humidity
is controlled. The area is protected from direct su nshin e, rain, or
direct wind.
Pollution degree 4. Pollution that generates persistent con ductivity
through con ductive dust, rain, or snow. Ty pical outdoor locatio ns.
xiv TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
Need help?
General
