RMX SERIES
1-48
483018 - 3/15 Terex South Dakota RMX Series
OPERATION GUIDELINES
LEAVING THE JOB SITE
1. Articulate jib parallel with the upper boom before storing upper boom. Retract jib fully and pin for travel.
2. Rotate platform to stowed position.
3. Place upper and lower boom in the proper stored position for traveling. Upper boom must be locked in
place with hold-down latch. Store booms in rests so boom deflection is removed and boom weight is
supported. Do not lower boom down so it deflects downward in the middle.
4. Retract all outriggers and properly store outrigger pads and chocks.
5. Stow all loose items or equipment.
6. Disengage PTO to prevent damage.
7. Shut off master switch.
8. Make final inspection that everything is properly stored.
9. Turn off warning lights.
10. Disengage brakes.
11. When traveling, remember overall height of vehicle.
12. If any problems were encountered during working operation, report them to the proper person(s) for
maintenance and repair.
NOTE: If any problems were encountered during working operation, report them to the proper
person(s) for maintenance and repair.
DRIVE CAREFULLY!
The upper boom must be completely secured with the hold-down strap in its rest before
travel. If the boom is allowed to bounce in its rest, the fiberglass may craze, shatter, and
eventually buckle.
To Next Page
Loading...
Need help?
General
