APPENDIX A
Appendix A Terex South Dakota, Inc. A-1
APPENDIX - A
APPENDIX - A
STANDARDS AND REGULATIONS
In addition to the operational instructions provided herein, various standards and governmental regulations
must be followed in the use and operation of your Terex South Dakota, Inc. unit.
ANSI STANDARDS
ANSI standards that are applicable to the operation and maintenance of your unit:
1. ANSI A92.2 (latest revision) Vehicle Mounted Elevating and Rotating Aerial Devices,
2. ANSI A10.31 (latest revision) Digger Derricks - Safety Requirements, Definitions and Specifications (A
partial extraction is included in this appendix),
3. ANSI C2, Part 4 (latest revision) (National Electric Safety Code®) Rules for the Operation of Electric
Supply and Communication Lines and Equipment,
4. ANSI Z133.1 (latest revision) Safety Requirements for Tree Pruning, Trimming, Repairing, or Removal.
For complete, current copies of ANSI standards, you must annually
write to the following:
American National Standards Institute
11 West 42nd Street
New York, NY 10036
Copies of the standards can also be found on the Internet at:
www.ansi.org
OSHA REGULATIONS
OSHA regulations that are applicable to the operation and maintenance of your unit:
1. OSHA Subpart V, Power Transmission and Distribution,
2. OSHA 1910.67, Vehicle Mounted Elevating and Rotating Cable Placers,
3. OSHA 1910.268, Telecommunications,
4. OSHA 1910.269, Electrical Power Generation, Transmission and Distribution,
5. OSHA Subpart M, Fall Protection,
6. OSHA 1910.147, The Control Of Hazardous Energy (Lockout/Tagout),
7. OSHA Subpart S, Electrical,
8. OSHA 1910.333, Selection and use of work practices.
9. OSHA Subpart CC, - Cranes and Derricks in Construction
For complete, current copies of OSHA regulations, you must annually write to the following or contact your
OSHA Regional Office.
Technical Data Center
Frances Perkins Department Of Labor Building
Room N2439
200 Constitution Avenue
Washington, DC 20210
Copies of the standards can also be found on the Internet at:
www.osha.gov.
These are not all inclusive of the applicable codes, standards, or regulations. It is your responsibility and
your employer's responsibility to identify and comply with applicable codes, standards and regulations.
The information provided herein is accurate as of the date your Terex South Dakota, Inc. unit was
manufactured. You must comply with the codes, standards and regulations as they are updated over time. It
is your employer's responsibility to obtain copies and comply with all standards and regulations.
To Next Page
Loading...
Need help?
General
