RMX SERIES
2-7
RMX Series Terex South Dakota 483018 - 3/15
MAINTENANCE GUIDELINES
DAILY ROPE INSPECTION
The synthetic rope must be inspected daily for any deterioration, resulting in appreciable loss of strength,
such as described below.
1. Excessive external roughness.
2. Glossy or glazed areas, which indicates heat damage.
3. Look for flat areas, bumps, or lumps, which indicates core or internal damage.
4. Cut or badly frayed strands.
5. Areas of discoloration, which could be caused by chemical contamination.
6. Stiffness, which would indicate excessive dirt or grit embedded or shock load damage.
7. Open the strands and look for powdered fibers, which means there is internal wear.
8. Inspect eye connection for proper weaving and damage.
If any of the above conditions are found it should be reported to a qualified person to determine if the
synthetic rope should remain in service. Further information can be found in the maintenance manual for
determining the replacement of the synthetic rope.
If there is any doubt or question about the condition of the synthetic rope -replace it!
HOOK INSPECTION
The load line hook and safety latch must be inspected daily. Any hooks showing defects shall be discarded.
Field repairs by welding or re-shaping shall not be permitted.
• Any damaged hook safety latch shall be replaced immediately.
• Any hook or fitting with a crack or distortion shall be removed from service immediately.
• Hook nut (if equipped) should be checked for corrosion or deformation.
• Refer to hook manufacturer for more specific inspection instructions.
Hook latches are to be used only as retention devices to retain loose rigging under slack
conditions. They are not intended to be anti-fouling devices and caution must be
exercised to prevent a latch from supporting any portion of a load. Periodic inspection of
the latch must be made to insure it’s proper operating condition. If damage to the latch
occurs, the latch must be replaced immediately.
To Next Page
Loading...
Need help?
General
