www.ti.com
Command Handler Supported Commands
Table G-1. DLP NIRscan Nano Supported Commands (continued)
COMMUNICATIONS INTERFACE
USB BLUETOOTH
READ /
DESCRIPTION
WRITE
OPCODE
CHARACTERISTI
SERVICE NAME SERVICE UUID
C UUID
BYTE 1 BYTE 2
0x43484103-444C-
5020-4E49-
GATT General 0x53455201-444C-
52204E616E6F,
READ Scan status 0x02 0x19 Information Service 5020-4E49-
0x43484104-444C-
Table I-3 52204E616E6F
5020-4E49-
52204E616E6F
WRITE Reset Tiva 0x02 0x1A
WRITE Write ADC PGA gain 0x02 0x1B
FACTORY USE ONLY: Write
WRITE 0x02 0x1C
DLPC150 Register
(1)
READ Read DLPC150 register 0x02 0x1D
WRITE Generate patterns 0x02 0x1E
Save given scan configuration
WRITE 0x02 0x1F
in EEPROM
0x43484114-444C-
5020-4E49-
52204E616E6F,
GATT Scan
0x53455205-444C- 0x43484115-444C-
Read stored scan Configuration
READ 0x02 0x20 5020-4E49- 5020-4E49-
configurations Information Service
52204E616E6F 52204E616E6F,
Table I-6
0x43484116-444C-
5020-4E49-
52204E616E6F
Erase all stored scan
WRITE 0x02 0x21
configurations
0x43484113-444C-
Read number of stored scan
READ 0x02 0x22 5020-4E49-
configurations
52204E616E6F
GATT Scan
0x53455205-444C- 0x43484117-444C-
Configuration
READ Read active scan configuration 0x02 0x23 5020-4E49- 5020-4E49-
Information Service
52204E616E6F 52204E616E6F
Table I-6
0x43484118-444C-
WRITE Set active scan configuration 0x02 0x24 5020-4E49-
52204E616E6F
WRITE DLPC150 power control 0x02 0x25
WRITE Set scan subimage 0x02 0x26
FACTORY USE ONLY: Erase
Calibration Coefficients,
Reference Calibration
WRITE 0x02 0x27
Coefficients, and Scan
Configuration stored in
EEPROM
(2)
READ Read PGA setting 0x02 0x28
FACTORY USE ONLY: Write
WRITE spectrum calibration 0x02 0x29
coefficients
(2)
(2)
Commands highlighted in red are for factory calibration. Erasing the factory calibration data will render a unit non-functional and
will need to be recalibrated.
59
DLPU030B–June 2015–Revised July 2015 DLP NIRscan Nano Command Description
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated