Chapter 12: Statistics 186
To begin entering, scrolling, or editing list elements, press †. The rectangular cursor is
displayed.
Note: If the list name you entered in step 2 already was stored in another stat list editor
column, then the list and its elements, if any, move to the current column from the previous
column. Remaining list names shift accordingly.
Creating a Name in the Stat List Editor
To create a name in the stat list editor, follow these steps.
1. Display the Name= prompt.
2. Press [letter from A to Z or q] to enter the first letter of the name. The first character cannot be a
number.
3. Enter zero to four letters, q, or numbers to complete the new user-created list name. List
names can be one to five characters long.
4. Press Í or † to store the list name in the current column of the stat list editor. The list
name becomes an item on the
LIST NAMES menu (Chapter 11).
Removing a List from the Stat List Editor
To remove a list from the stat list editor, move the cursor onto the list name and then press {. The
list is not deleted from memory; it is only removed from the stat list editor.
Notes:
• To delete a list name from memory, use the MEMORY MANAGEMENT/DELETE secondary
menu (Chapter 18).
• If you archive a list, it will be removed from the stat list editor.
Removing All Lists and Restoring L1 through L6
You can remove all user-created lists from the stat list editor and restore list names
L1 through L6
to columns 1 through 6 in either of two ways.
• Use
SetUpEditor with no arguments.
• Reset all memory (Chapter 18).
To Next Page
Loading...
Need help?
General
