Texecom Veritas Excel Master User Manual

Operating the Alarm System Veritas Excel Master User Guide
6 INS166-2
To UNSET the Alarm
Enter via a designated entry route, the slow entry tone will start and the display will
look like this:
D3$/0$%1#*$.
G"A.%D/00+"<$
12
3
4
56
78
Unset
Tampe r
Zones
Enter your 4-digit Access code
####
, the entry tone will stop and the
display will look like this (after 5 seconds the display will revert to normal):
BH0*$?%I#0$*
45%6/.%%78947:44
12
3
4
56
7
8
Unset
Tampe r
Zones
! "
During the last 10 seconds of the entry period the entry tone will change from slow
to fast.
To OMIT Zones When Setting
It is possible to exclude (omit) or include individual zones during setting.
Enter your 4-digit Access code
####
. Press
$
or enter Part Set
Suite number
#
and press
(
. Press
)
, the exit tone and exit timer will stop
and the display will look something like this:
@A33%B$*%J%=.?
!"#$0%78&KC5ELMD
12
3
4
56
78
Unset
Tampe r
Zones
! "
To display the descriptive text associated with a particular zone number, press
and hold the corresponding key
#
##
#
(LCD keypad only).
Press the number key(s)
#
… of the zone(s) to be omitted or included, the
display will look something like this:
@A33%B$*%J%=.?
!"#$0%78&KFFFLMD
12
3
4
56
78
Unset
Tampe r
Zones
Press
*
to complete the omitting procedure, the system will revert back to the exit
mode and the exit tone will restart.
! "
Only zones that have been programmed as omittable by the Installer can be
omitted.
The system will automatically return to exit mode 16 seconds after the last key is
pressed.
If the system has a power fault i.e. a mains failure, this will be indicated by a ‘P’ on
the display or the Unset light flashing.
The system can still be set, by omitting zone number
+
, unless programmed
otherwise by your installer.

Texecom Veritas Excel Master Specifications

General

Brand	Texecom
Model	Veritas Excel Master
Category	Security System
Language	English