ThyssenKrupp Flow2 User Manual

2007.03.07 Flow2 stairlift Tab 06: Systematic fault finding
www.ThyssenKruppAccessibility.nl 31
Error messages
Description This fault occurs when the swivel is turned more than 360º or because the swivel
is not in the right position.
Priority Low
Possible
solution
- Bring the swivel to the 0 position with the [E] button in mode 3.
Then switch the lift off and on.
- Check the swivel optocoupler.
- Check the swivel encoder.
- If the fault persists, the programmed rail data must be checked.
Reset Stop the lift
Modes 0, 2
Error code E71
Type of error System error / control error
Error message RF error
Description This message indicates that the receiver board is not responding.
Priority Low
Possible
solution
- Switch the lift off and on.
- If the fault persists, check the connection between the main board and the
receiver module. Replace the receiver module if necessary.
Reset Switch off and on.
Modes 0, 2
Error code E72
Type of error System error / control error
Error message Main drive brake skid error
Description This fault indicates that the brake is slipping.
This test is carried out every time the lift is stopped.
Priority Low

ThyssenKrupp Flow2 Specifications

General

Brand	ThyssenKrupp
Model	Flow2
Category	Stairlifts
Language	English