ENGINE OPERATION28
7
8. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00043-C
ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5 Υ )
5 minutes at 2000 rpm : above 41°F (5 Υ )
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1. Cooling water check port
ENOM00044-B
Engine speeds
Idling speed after warming up.
ENOM00046-A
ENOW00037-0
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
z Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
z Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
z Arrange the tether so that will not be
caught by any object when pulled.
z Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop
of engine can cause loss of control of
outboard motor. Rapid loss of engine
power can lead to falling down or caus-
ing passenger(s) to be thrown over-
board.
ENOW00042-0
z Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/
or hull may be damaged.
3. Warming up the engine
CAUTION
ENOF02021-0
1
ENOF02022-0
Model
Trolling speed
(in Forward)
Idling speed
(in Nutral)
2.5A2 1,100 rpm -
3.5A2 1,100 rpm -
3.5B2 1,100 rpm 1,300 rpm
4. Forward, reverse, and
acceleration
WARNING
WARNING
WARNING
To Next Page
Loading...
Need help?
General
