INSPECTION AND MAINTENANCE44
10
ENOM01306-0
It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or number
of months, whichever comes first.
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the best
time for major maintenance procedures to be carried out.
2. Periodic Inspection
Item
Servicing Interval
Action Remarks
10 hours
or
1 month
50 hours
or
3 months
Every 100
hours or
6 months
Fuel System
Carburetor *1
z
Clean, and adjust.
Fuel filter
zzz
Check and clean or Replace.
Piping/Hose
z Check and Replace.
Fuel tank
zzzClean.
Ignition Spark plugs
zzz
Check gaps. Remove carbon deposits or
Replace.
0.9–1.0 mm
(0.035–0.039 in)
Starting
System
Starter rope
zzzCheck for wear or chafting.
Lower Unit
Propeller
zzzCheck for bent blades, damage, wear.
Shear pin &
Split pin
zzzCheck and Replace.
Gear oil
zzz
Replace or Fill gear oil and check for
water leaks.
180 mL (6.1 fl.oz.)
: 3.5B2
90ml (3.0 fl.oz.) :
2.5A2/3.5A2
Water pump *1
z Check for wear or damage.
Bolt and Nuts
zzzRetighten.
Sliding and Rotating Parts.
Grease Nipples
zzApply and pump in grease.
Outer Equipment
zzzCheck for corrosion.
Anode
zzCheck for corrosion and deformation.
To Next Page
Loading...
Need help?
General
