ENGINE OPERATION 35
1. FDV in fuel hose
2. Sealing mechanism in fuel connector
3. Identification
Do NOT use a primer bulb/hose assembly
that does not contain a Fuel Demand Valve
or a sealing mechanism as shown below:
otherwise overflow the fuel system or fuel
spillage may occur.
ENOM00045-0
1. Be sure to install the stop switch lock
to the stop switch.
1. Stop switch lock
MF, MFG, EF, EFG, EFT type
2. Place the shift lever in the Neutral posi-
tion.
Be sure that the shift is in Neutral when
starting the engine.
This model is provided with start in
gear protection.
ENOW00031-0
If the engine starts in gear, do not use it.
Contact an authorized dealer.
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift. In-
gear starting of engine will move the boat
immediately, potentially leading to falling
down or causing passenger(s) to be thrown
overboard.
3. Set the throttle grip to “START” posi-
tion.
3. Starting
CAUTION
R
F
N
ENOF00038-0
MFS25-30B_EN.book Page 35 Wednesday, December 12, 2012 11:58 AM
To Next Page
Loading...
Need help?
General
