Fig. 3 illustrates the safety plate: this must applied directly to the outside of the
actuator or near it and always in a position where it can be seen by the installer and/or
operator.
4.4- RESIDUAL RISKS
The device does not have residual risks. The installer and the user are herewith
informed that after the actuators have been installed on the window, the automatic
enabling of the same can accidentally generate the following residual risk:
Residual risk:
Hazard of squashing or dragging of body parts inserted between the movable and the
fix part of the window frame.
Exposure frequency:
Accidental and when the installer or the user decides to perform a wrong voluntary
action.
Severity of the damage:
Light lesions (usually reversible).
Adopted measures:
1) Manual control (radio control or push-button): It is compulsory to verify that near the
window there are not persons, animals or things whose safety may be accidentally
jeopardized. During actuator operation, it is compulsory to be in a safe control
position assuring visual control on the window movement.
2) Automatic control (sensors): It is compulsory to place on the window suitable safety
signals and/or to install a suitable acoustic/light signaller nearby.
If the movable part of the window is under 2.5 m respect to the floor, it would be
advisable to use actuator in according with the EN 60335-2-103 directive or shield
the dangerous parts with suitable safety .
In order to assist installers in applying the European regulations and directives
regarding the safety and use of the motorized actuator, a special downloadable
guide is available from our website www.topp.it.
11
ISTRUZIONI PER L'INSTALLAZIONE E L’USO
TF24R/44R
4- SAFETY
To Next Page
Loading...
Need help?
General
