Replacing the TEC Fuse
G439126
1. Prepare the machine for maintenance.
2. Unlatch and open the hood.
3. At the front, left side of the engine, remove the
cover of the in-line fuse holder
.
4. Replace the open fuse with a fuse of the same
type and amperage rating.
5. Assemble the cap to the in-line fuse holder.
6. Close and latch the hood.
Drive System Maintenance
Checking the Tire Pressure
WARNING
Low tire pressure decreases machine side hill stability. This could cause a rollover,
which could result in death or serious injury.
Do not under-inflate the tires.
Note: Maintain the recommended pressure in all tires to ensure a good quality of cut and
proper machine performance.
1. Measure the air pressure in each tire. The correct air pressure in the tires is 83 to 103
kPa (12 to 15 psi).
2. If needed, add air to or remove air from the tires until you measure 83 to 103 kPa (12 to
15 psi).
Maintenance: Electrical System Maintenance Page 6–25 3464-490 A
To Next Page
Loading...
Need help?
General
