During Operation
Overview of the Machine Operating Characteristics
• This machine has an automotive-style throttle that is controlled by the traction pedal.
• This machine does not have a separate throttle switch or throttle lever.
• When you remove your foot from the traction pedal, the machine dynamically brakes to a
stop.
• The pedal controls are optimized to provide a reactive yet stable response, allowing you
to maintain consistent control over rough terrain, while still allowing for quick, smooth
braking.
• While transporting, the traction pedal will operate similar to a car and change the engine
and traction speed dependent on the traction pedal position.
• When mowing, the engine speed will automatically raise to high idle.
• If the engine is at low idle, performing a function like lifting the cutting units or pressing
the traction pedal raises the engine speed to a minimum working speed, providing
enough power to efficiently perform the function.
• The maximum speeds set in the PIN protected menu settings are set by the supervisor to
limit the machine’s maximum traction speed.
• The achievable traction pedal use, cruise control, and pedal stop traction speeds are all
limited by the maximum speeds set in the PIN protected menu.
Machine Operation
• If an obstacle is in the way, lift the cutting units or mow around it.
• When transporting the machine between work areas, shut off the PTO, and raise the
cutting units to the fully upward position. This allows the traction pedal to operate like a
car.
• Always drive slowly in rough areas.
• Never shut off the machine while driving the machine.
Practice Operating the Machine
To get familiar with the features of the machine, practice operating the machine.
1. Lift the cutting units, disengage the parking brake, press the forward traction pedal, and
carefully drive to an open area.
2. Practice driving the machine, because it has a hydrostatic transmission and its features
can differ from other turf-maintenance machines.
3. Practice moving forward and reverse, and starting and stopping the machine. To stop
the machine, remove your foot from the traction pedal and let it return to N
EUTRAL.
Note: When going downhill in the machine, you may need to engage the parking-brake
switch or use the reverse pedal to stop.
4. Practice driving around obstacles with the cutting units up and down. Be careful when
driving between narrow objects so that you do not damage the machine or cutting units.
3464-482A Page 5–15 Operation: During Operation
To Next Page
Loading...
Need help?
General
