Operation
Before Using the Pole Saw
Before using the pole saw , do the following:
• Check the chain tension; refer to Adjusting the
Chain T ension ( page 19 ) .
• Clean the pole saw components, inspect them for
excessive wear or damage, and replace them as
needed; refer to Servicing the Guide Bar , Chain,
and Drive Sprocket ( page 20 ) .
• Check the chain for sharpness and damage, and
sharpen or replace as needed; refer to Sharpening
the Chain ( page 22 ) .
• Check the oil level; refer to Checking the Oil Level
and Adding Bar and Chain Oil ( page 18 ) .
• Check the pole saw for damage, general
appearance, and performance; ensure that the
switches move freely , the vents and handles are
clean, and the bar is not bent or damaged.
Starting the Pole Saw
Important: Use the battery pack only in
temperatures that are within the appropriate
range; refer to Specications ( page 14 ) .
1. Ensure that the vents on the pole saw are free
from dust and debris ( Figure 10 ).
g374231
Figure 10
1. V ents
2. Set the pole saw down on a level surface.
3. Align the cavity in the battery pack with the
tongue on the handle housing ( Figure 1 1 ).
g334268
Figure 1 1
4. Push the battery pack into the handle until the
battery pack locks into place.
5. Remove the protective cover from the chain.
6. Press the trigger lock, then press the trigger to
start the pole saw .
Shutting Off the Pole Saw
T o shut of f the pole saw , release the trigger .
Whenever you are not using the saw or are
transporting the saw to or from the work area remove
the battery pack; refer to Removing the Battery Pack
( page 17 ) .
15
To Next Page
Loading...
Need help?
General