Toro Flex-Force Power System 60V User Manual

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
Before each use or daily
• Check the oil level and add bar and chain oil if necessary .
• Check that oil is owing to the chain.
• Check the chain tension and adjust it if necessary .
• Ensure that the bar is straight and undamaged
• Check the chain for sharpness; contact an Authorized Service Dealer to have the
chain sharpened or replaced.
After each battery drain
cycle
• Check the oil level and add bar and chain oil if necessary .
• Check the chain tension and adjust it if necessary .
Y early or before storage
• Service the guide bar , chain, and drive sprocket.
• Check the chain for sharpness; contact an Authorized Service Dealer to have the
chain sharpened or replaced.
Checking the Oil Level and
Adding Bar and Chain Oil
Service Interval : Before each use or daily
After each battery drain cycle
Important: Use only bar and chain oil (sold
separately).
1. Shut of f the pole saw and remove the battery
pack; refer to Removing the Battery Pack ( page
17 ) .
2. Check the oil level in the window . If the oil does
not ll the window , add bar and chain oil as
needed ( Figure 16 ).
g374235
Figure 16
1. Oil window 2. Oil cap
3. Place the pole saw on a at surface with the oil
cap facing up.
4. Clean the area around the oil cap ( Figure 16 ).
Note: Ensure that you do not allow debris/wood
chips to enter the oil tank.
5. Remove the cap, and pour bar and chain oil into
the pole saw until the oil lls the tank ( Figure 16 ).
Important: Do not ll the pole saw higher
than the bottom of the ll neck.
6. Clean up any spilled oil and secure the oil cap.
7. Ensure that oil is owing to the chain; refer to
Checking the Flow of Bar and Chain Oil ( page
18 ) .
Checking the Flow of Bar
and Chain Oil
Service Interval : Before each use or daily
1. Prepare to use the pole saw; refer to Before
Using the Pole Saw ( page 15 ) .
2. T o ensure that oil is owing to the chain, point
the nose of the pole saw a few inches from a
surface (e.g. paper , cardboard, a stump) and
run the pole saw; you should be able to see a
light spray of oil on the surface ( Figure 17 ).
g374236
Figure 17
1. Run the pole saw a few
inches from a surface.
2. If the oil is owing, it will
spray of f the chain and
accumulate.
18

Toro Flex-Force Power System 60V Specifications

General

Brand	Toro
Model	Flex-Force Power System 60V
Category	Pole Saw
Language	English