Toro Flex-Force Power System 60V User Manual

T roubleshooting
Perform only the steps described in these instructions. All further inspection, maintenance, and repair work
must be performed by an authorized service center or a similarly qualied specialist if you cannot solve the
problem yourself.
Always remove the battery from the tool when troubleshooting, inspecting, maintaining, or cleaning the tool.
Problem
Possible Cause Corrective Action
1. The battery pack is low on charge.
1. Charge the battery pack.
2. The battery pack is not fully seated.
2. Ensure that the battery pack is inserted
all the way into the housing.
3. The battery pack is over or under the
appropriate temperature range.
3. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
4. The battery pack has exceeded high
amperage limits.
4. Release the trigger , then press the
trigger switch.
5. There is moisture on the leads of the
battery pack.
5. Allow the battery pack to dry or wipe it
dry .
The pole saw does not run or does not run
continuously .
6. There is debris under the cover . 6. Remove the cover and clean out any
debris.
1. The chain is not properly seated on the
drive sprocket.
1. Install the chain and ensure that the
links are properly seated in the drive
sprocket.
The pole saw runs, but the chain does not
rotate.
2. There is debris under the cover . 2. Remove the cover and clean out any
debris.
1. The chain is not tensioned correctly .
1. Set the proper tension on the chain.
2. The chain is dull or damaged. 2. Replace the chain.
3. The guide bar is bent or the grooves
are damaged.
3. Replace the guide bar
4. The chain is installed backward. 4. Install the chain correctly .
The pole saw does not properly cut.
5. The chain is not being lubricated
properly .
5. Check the oil level and ensure that oil
is owing to the chain.
1. The oil level is low .
1. Check the oil level.
2. The oil outlet is plugged.
2. Clean out debris from the oil outlet.
3. There is debris under the cover . 3. Remove the cover and clean out any
debris.
The chain oil is not lubricating properly .
4. The oil channel or groove in the guide
bar is plugged.
4. Clean out debris in the bar .
1. The battery pack is over or under the
appropriate temperature range.
1. Move the battery pack to a place
where it is dry and the temperature is
between 5°C (41°F) and 40°C (104°F).
2. The chain is dull or damaged. 2. Replace the chain.
3. The guide bar is bent or the grooves
are damaged.
3. Replace the guide bar
4. The machine is overloaded. 4. Apply less pressure when cutting.
The battery pack loses charge quickly .
5. The chain is not being lubricated
properly .
5. Check the oil level and ensure that oil
is owing to the chain.
1. The battery charger is over or under
the appropriate temperature range.
1. Unplug the battery charger and move
it to a place where it is dry and the
temperature is between 5°C (41°F)
and 40°C (104°F).
The battery charger is not working.
2. The outlet that the battery charger is
plugged into does not have power .
2. Contact your licensed electrician to
repair the outlet.
23

Toro Flex-Force Power System 60V Specifications

General

Brand	Toro
Model	Flex-Force Power System 60V
Category	Pole Saw
Language	English