27
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 10 hours
• Check PTO Belt Tension
• Check Fan and Alternator Belt Tension
• Change Transmission Filter
• Torque Wheel Lug Nuts
After first 50 hours
• Change Engine Oil and Filter
• Torque Head, Adjust Valves and Check Engine RPM
Every 50 hours
• Check Battery Fluid Level
• Check Battery Cable Connections
• Lubricate All Grease Fittings
• Lubricate Brake Cables
• Check Cutting Unit Gear Box Oil Level
• Clean Under Cutting Unit Belt Covers
• Check Cutting Unit Drive Belt Adjustment
• Inspect Air Filter, Dust Cup, and Baffle
Every 100 hours
• Change Engine Oil and Filter
• Check Electric Clutch Gap Adjustment
• Check PTO Belt Tension
• Check Fan and Alternator Belt Tension
• Inspect Cooling System Hoses
Every 200 hours
• Check Rear Wheel Toe–In and Steering Linkage
• Change Transmission Filter
• Torque Wheel Lug Nuts
Every 400 hours
• Service Air Filter
• Change Cutting Unit Gear Box Oil
• Change Electric Fuel Pump Filter
• Pack Rear Wheel Bearings
• Coat Transmission Bypass Pins with Grease
• Torque Head, Adjust Valves and Check Engine RPM
Every 1000 hours
• Replace Moving Hoses
• Replace Safety Switches
• Coolant System – Flush/Replace Fluid
• Replace Hydraulic Oil
To Next Page
Loading...
Need help?
General
