26
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first 10 hours
• Check the fan and alternator belt tension.
• Torque the wheel lug nuts.
After first 50 hours
• Change the engine oil and filter.
• Check the engine RPM (idle and full throttle).
• Change the hydraulic filter.
• Change the front planetary gear lube
Every 50 hours
• Lubricate all grease fittings.
• Check the air cleaner.
1
• Check the battery fluid level and cable connections.
• Lubricate reel control valve grease fitting
• Lubricate reel speed valve with oil
Every 100 hours
• Drain water from hydraulic tank
• Inspect the cooling system hoses.
• Check the fan and alternator belt tension.
Every 150 hours • Change the engine oil and filter.
Every 200 hours
• Torque the wheel lug nuts.
• Inspect cutting unit reel drive belts
Every 400 hours
• Service the air cleaner.
1
• Replace the fuel filter.
• Check the engine RPM (idle and full throttle).
• Inspect fuel lines and connections
Every 800 hours
• Drain and clean fuel tank
• Change the hydraulic filter
• Change hydraulic tank breather
• Check rear wheel toe-in.
• Pack the 2WD rear wheel bearings.
• Change the front planetary gear lube
• Adjust valves
Every 1600 hours or
every 2 years,
whichever occurs first
• Replace all moving hoses.
• Flush/replace the cooling system fluid.
• Drain/flush hydraulic tank.
1
Service air cleaner whenever indicator shows red
Important Refer to your engine operator’s manual for additional maintenance procedures.
To Next Page
Loading...
Need help?
General
