Toro Snow Commander User Manual

Snow Commander Service Manual 5 - 5
ELECTRIC START SYSTEM
NOTE: When installing the wires, install the black
wires directly across from each other and the light
wires across from each other (Figure 68).
Figure 68
3428-0261
Starter Pinion Replacement
In order to replace the pinion, the upper shroud must
be removed and at least the two motor mounting
screws removed. If you know the wire, switch, and
motor are all ok, they can be left in place. Refer to
"System Disassembly" on page 5 - 1.
With the motor mounting screws removed, the motor
can be accessed from the top. To remove the pinion,
push the pinion stop down to uncover the wire lock ring
around the end of the armature (Figure 69). The lock
ring can be grasped with a pliers or side cutters and
pulled off. Replace the ring; do not re-use. With the ring
off the pinion and spring can be removed (Figure 70).
Figure 69
3428-0264
Figure 70 3428-0266
(A) Ring (B) Pinion Stop
(A) & (B) Pinion Assembly
(C) Pinion Stop
(D) Spring
(E) Lock Ring
A
B
B
A
C
D
E

Toro Snow Commander Specifications

General

Brand	Toro
Model	Snow Commander
Category	Snow Blower
Language	English