Toro Workman MD Service Manual

Workman MDXPage 3 -- 16Briggs & Stratton Gasoline Engine
11. Disconnect electrical connections from the following
engine components:
A. Disconnect ground cable to engine at starter/
generator terminal A1 (Fig. 15).
B. Disconnect engine harness connector from the
main harness.
12.Remove four (4) flange nuts and cap screws secur-
ing the engine to the engine tray.
CAUTION
One person should operate the hoist while the
other person guides the engine out of the frame.
13.Remove engine from the engine tray.
A. Attach a short section of chain between both en-
gine lift tabs.
B. Connect hoist to center of chain.
IMPORTANT: Make sure to not damage the en-
gine, fuel hoses, electrical harness or other parts
while removing the engine.
C. Slowly remove engine from the machine.
14.Remove engine parts and attachments as neces-
sary to repair the engine.
Engine Installation (Fig. 12)
1. Install all removed parts and attachments to the en-
gine.
CAUTION
One person should operate the hoist while the
other person guides the engine into the frame.
2. Install engine to the engine tray.
A. Attach a short section of chain between both en-
gine lift tabs.
B. Connect a hoist at the center of the short section
of chain.
IMPORTANT: Make sure to not damage engine,
fuel lines, electrical harness or other parts while
installing the engine.
C. Carefully lower engine onto the engine tray.
Figure 16
1. Oil filter adapter
2. Oil filter
3. Filter bracket
4. Cap screw
5. Flange nut
6. Engine
3
5
6
2
1
4
3. Install four (4) cap screws and flange nuts to engine
and engine tray. Position engine on engine tray to align
clutch drive pulley and driven pulley on transaxle. Tight-
en fasteners.
4. Carefully position oil filter assembly to filter bracket
(Fig. 16). Secure filter adapter with two (2) cap screws
and flange nuts.
5. Connect the following electrical components:
A. Connect ground cable from the engine at starter/
generator terminal A1 (Fig. 15).
B. Connect engine harness connector to the main
harness connector.
6. Install starter belt to the engine and starter/generator
pulleys. Tension the belt by rotating the starter/genera-
tor away from the engine. Tighten fasteners to secure
starter/generator.
7. Install drive belt to drive clutch.
IMPORTANT: Make sure to remove all plugs and
covers that were placed on hose and engine open-
ings during engine removal.
8. Install muffler and exhaust coupler to the machine
(see Exhaust System Installation in this section).
9. Connect fuel inlet hose to the fuel pump (Fig. 13).

Toro Workman MD Specifications

General

Brand	Toro
Model	Workman MD
Category	Utility Vehicle
Language	English