Toro Workman MD Service Manual

Rev. A
Workman MD/MDX
Drive Train
Page 5 -- 6
Special Tools
Order special tools from your Toro Distributor.
Drive Clutch Removal Tool (Serial Number Below 310000000)
This tool is required to remove the drive clutch from the
tapered drive shaft of the engine. It is placed in the
threaded hole of the fixed clutch sheave after the clutch
holding cap screw is removed.
Toro Part Number: TOR4094
NOTE: Vehicles with a serial number below 310000000
are equipped with a Comet brand drive c lutch.
Figure 6
Drive Clutch Spider Removal Tool Kit (Serial Number Below 310000000)
This kit is required to r emove the drive clutch spider from
the post of the fixed sheave. Kit includes spanner and
clutch holding bar.
Toro Part Number: TOR4098
NOTE: Vehicles with a serial number below 310000000
are equipped with a Comet brand drive c lutch.
1. Holding bar 2. Spanner
Figure 7
1
3
2
4
1
2
Clutch Dry Lubricant (Serial Number Below 310000000)
This lubricant should be used to properly lubricate drive
clutch components on vehicles with serial numbers be-
low 310000000.
Toro Part Number: 104--7011
NOTE: Vehicles with a serial number below 310000000
are equipped with a Comet brand drive c lutch.
Figure 8

Toro Workman MD Specifications

General

Brand	Toro
Model	Workman MD
Category	Utility Vehicle
Language	English