Drive System
Maintenance
Checking the Seat Belt
Service Interval : Before each use or daily
Inspect the seat belt for wear , cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Adjusting the T racking
1. Disengage the blade-control switch (PT O).
2. Drive to an open, at area and move the
motion-control levers to the N EUTRAL - LOCK
position.
3. Move the throttle midway between the F AST and
S LOW positions.
4. Move both motion-control levers forward until
they both hit the stops in the T -slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, insert a 3/16
inch hex wrench through the access hole in the
left, front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever ( Figure 73 ).
7. If the machine tracks to the left, insert a 3/16
inch hex wrench through the access hole in the
right, front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever ( Figure 73 ).
8. Drive the machine and check the full forward
tracking.
9. Repeat the adjustment until the desired tracking
is obtained.
g334735
Figure 73
Right control lever shown
1. T racking screw
2. Access hole on the front
cover panel
56
To Next Page
Loading...
Need help?
General
