Toro Z Master 4000 Series User Manual

Controls System
Maintenance
Adjusting the
Control-Handle Position
If the ends of the levers hit against each other , refer to
Adjusting the Motion-Control Linkage ( page 61 ) .
Adjusting the Height
Y ou can adjust the motion control levers higher or
lower for maximum comfort.
1. Park the machine on a level surface, disengage
the blade-control switch (PT O), and engage the
parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the hardware holding the control lever
to the control-arm shaft.
g035858
Figure 79
1. Bolts
3. Control lever
2. Slotted hole 4. Control-arm shaft
4. Move the control lever to the next set of holes.
Secure the lever with the hardware.
5. Repeat the adjustment for the opposite control
lever .
Adjusting the T ilt
1. Park the machine on a level surface, disengage
the blade-control switch (PT O), and engage the
parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the upper bolt holding the control lever
to the control arm shaft.
4. Loosen the lower bolt just enough to pivot the
control lever fore or aft. T ighten both bolts to
secure the control in the new position.
5. Repeat the adjustment for the opposite control
lever .
g009195
Figure 80
60

Toro Z Master 4000 Series Specifications

General

Brand	Toro
Model	Z Master 4000 Series
Category	Lawn Mower
Language	English