EasyManuals Logo
Home>Torqeedo>Outboard Motor>Cruise 2.0 R/T

Torqeedo Cruise 2.0 R/T User Manual

Torqeedo Cruise 2.0 R/T
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
71
DeutschEnglish
5.3 Remote throttle control (Cruise R)/ tiller (Cruise T) with integrated display
and magnetic key
5.3.1 Use of battery charge display when operating with Power 26-104 battery
5.3.1.1 Establishing communication between Power 26-104 and
Cruise outboards
To establish communication between battery and outboard, a one-time calibration is
necessary.
SwitchthemainswitchofyoursystemtotheONposition.
Afterwards,inaquicksequence,pushrsttheON/OFFbuttonbelowthedisplay(located
on the remote throttle or on the tiller) and afterwards the CAL button below the display.
The CAL button needs to be pushed while the system is booting. During this phase, all
the symbols in the display are displayed.
Afterwards the components establish the communication among themselves automati-
cally. During this phase, the display is showing ENU (for enumeration). It further shows
the progress in percent and the number of detected batteries.
After the process is completed, the progress counter shows 100% and the number of
connected batteries.
Switch off the entire system now. Motor and battery are now communicating directly
with each other. This enables you – among others – to look up the charge state of your
batteries on the display.
Please be aware, that for older Cruise models, the communication between outboard and
Power 26-104 may not be available. Contact Torqeedo Service for questions.
5.3.1.2 Setup menu for display options
1.Toenterthesetupmenupressthe“setup”button.
2. Select the units in which the remaining range is displayed. Push the button in the
center of the display to select between kilometers, miles, nautical miles, and hours. You
conrmyourselectionbypressing“setup”again.
3. Now, enter the speed indicator setting. You can choose between kilometers per hour,
miles per hour, and knots. Again you select the units with central button. Confirm your
selectionbypressing“setup”again.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Torqeedo Cruise 2.0 R/T and is the answer not in the manual?

Torqeedo Cruise 2.0 R/T Specifications

General IconGeneral
BrandTorqeedo
ModelCruise 2.0 R/T
CategoryOutboard Motor
LanguageEnglish

Related product manuals