EasyManuals Logo
Home>Torqeedo>Outboard Motor>Cruise 2.0 R/T

Torqeedo Cruise 2.0 R/T User Manual

Torqeedo Cruise 2.0 R/T
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
76
DeutschEnglish
5.3.4 Error message / Troubleshooting
• RepairsmayonlybecarriedoutbyauthorisedTorqeedoServiceCenters.
Any attempts of unauthorized repairs or modification will entail loss of
warranty.
• Pleasenotethatopeningthepylonand/ortheinnershaftheadcover
will entail loss of warranty.
• Inwarrantycasespleasefollowthewarrantyinstructionsatthetopof
the operating manual.
Display Cause What to do
E02 Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E05 Motor/propeller blocked Switchmainswitchto”OFF”position,thenremove
blockage and turn propeller one revolution by hand.
Reconnect motor cable.
E06 Voltage in the motor too
low
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
E07 Motor overcurrent Continue at low output.
E08 Circuit board overheating Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E21 Tiller calibration defective •Re-calibrate:Press“cal”buttonfor10seconds.
•Thedisplayshows“calup”:Presstillerforwardtofull
gasthenpressthe“cal”button.
•Thedisplayshows“calstp”:Returntillertocentralposi-
tionthenpressthe“cal”button.
•Thedisplayshows“caldn”:Presstillerbackwardtofull
gasthenpressthe“cal”button.
E22 Magnetic sensor defective Re-calibrate (refer to E21)
E23 Value range false Re-calibrate (refer to E21)
E30 Motor communication
error
Checkthemotorcable’splug-inconnection.Checkthe
motor cable for damage.
E32 Tiller/Remote throttle Check the plug-in connections. Check the cable.
E33 General communication
error
Check the plug-in connections and cables. Switch the
motor off and on again.
E41, E42 Incorrect charging voltage Use a Torqeedo power supply. If the error occurs in spite
of using a Torqeedo power supply, wait untill the battery
dissipates the overcharge. Should the error persist please
contact Torqeedo Service.
E43 Battery empty Charge battery. Motor can potentially be used again slowly
from the stop position.
E45 Battery overcurrent Switch motor off and on again. If this error occurs the
battery status indicator and range display can no longer
operate until the battery has been fully charged again.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Torqeedo Cruise 2.0 R/T and is the answer not in the manual?

Torqeedo Cruise 2.0 R/T Specifications

General IconGeneral
BrandTorqeedo
ModelCruise 2.0 R/T
CategoryOutboard Motor
LanguageEnglish

Related product manuals