GENERAL ADJUSTMENTS
– 11 –
DESIGN MODE
2) While pressing CALL button
again and press MENU button
on the TV.
3) Press MENU button on TV.
ITEM
DATA
S D
Press
(Design mode) (Adjustment mode)
Press
1. ENTERING TO DESIGN MODE
1) When in Service mode (see
page 8), press CALL button
on the remote control once.
When QA10 is initialized, items “OPT” ,“OPT1” and “OPT2” of DESIGN MODE are set to the data of the representative model
of this chassis family.
Therefore, because ON-SCREEN specification remains in the state of the representative of model. This model is required to
reset the data of items “OPT” ,“OPT1” and “OPT2” according to current on-serviced model .
2. SELECTING THE ADJUSTING ITEMS
Every pressing of CH t button in the design mode changes the adjustment items in the order of table-3.
(s button for reverse order)
Refer to table-3 for data of design mode.
(See SETTING & ADJUSTING DATA on page 14)
3. ADJUSTING THE DATA
Pressing of ; -/+ buttons will change the value of data.
To Next Page
Loading...
Need help?
General
