HOW TO USE THE FAX FUNCTION
4-1
The standalone fax component of your unit offers a range of sophisticated features
that allow you to control image quality, reception mode, broadcasting, polling, and
transmission priorities. Functions such as sending documents from memory and
substituting reception into memory are greatly enhanced by the large memory capacity.
Sending Documents
Setting the Document
Original face up
This section describes setting documents in the ADF (Auto Document Feeder) or on
the original table.
When Using the ADF:
1
Confirm that there are no
documents on the original table,
and that copying is not in
progress, then gently close the
original cover.
2
Adjust the document guides to
the width of your document.
3
Place the document face up and
push it gently into the document
tray. The top edge of the
document should enter the fax
first.
4
There are two ways to send the
fax:
• To scan the document into
memory, then dial and transmit,
continue with the “Dialing and
Transmitting” section.
• To dial and transmit the document
directly without first scanning it into
memory, press the DOCUMENT
key. “DIRECT SEND” will appear
in the display. Continue with the
“Dialing and Transmitting” section.
4. HOW TO USE THE FAX FUNCTION
To Next Page
Loading...
Need help?
General
