User’s Manual 8-17
AV functions
2. Connect the other end of the infrared transmitter cable to a set-top box.
It is placed in front of the infrared receiver window on the set-top box to
allow the Full size remote controller to be used to change channels.
3. Connect the end of coaxial cable (1) to the TV antenna port of your
computer. Refer to Connecting the coaxial cable section in Chapter 4,
Operating Basics, for details.
4. Connect the other end of the coaxial cable (1) to the Splitter Out port of
a splitter.
5. Connect the end of the coaxial cable (2) to the Splitter In port of a
splitter.
6. Connect the other end of the coaxial cable (2) to the Satellite Out port of
a set-top box.
7. Connect the end of the CATV cable to the Satellite In port of a set-top
box.
8. Connect the other end of the CATV cable to the wall socket.
Figure 8-17 Connection method for the computer and set-top box
Media Center Environment Settings
Activating Media Center for the first time
1. Activate Media Center.
The setup screen appears. Configure settings according to your
environment.
Follow the screen instructions and configure settings according to the
environment used.
Changing settings
Refer to the following procedures to change settings that are already
configured.
1. Activate Media Center.
2. Click in the following order: click Tasks -> settings -> TV -> Set Up TV
Signal.
CATV cable
Coaxial cable (2)
Wall socket
Splitter
Splitter Out port
Splitter In port
Set-top box
Satellite Out port
Satellite In port
Coaxial cable (1)
Infrared transmitter cable
To Next Page
Loading...
Need help?
General