-62-
Emergency Response (2012 Model - Continued)
Extrication (Continued)
• Disable Vehicle
Perform these steps first if the charge cable assembly is
connected to the vehicle.
1. Disconnect the charge cable assembly connector from the
vehicle. To disconnect it, push the lock release button on the top
of the connector and pull it away from the vehicle.
2. Close the charge inlet cap and charge inlet door.
3. Disconnect the plug of the charge cable assembly from the
electrical outlet.
Performing either of the following two procedures will shut the
vehicle off and disable the HV battery assembly, SRS, gasoline fuel
pump, and optional remote air conditioning system.
Procedure #1
1. Confirm the status of the READY indicator in the instrument
cluster. If the READY indicator is illuminated, the vehicle is on
and operational.
2. Shut off the vehicle by pushing the power button once.
3. The vehicle is already shut off if the instrument cluster lights are
not illuminated. Do not push the power button because the
vehicle may start.
4. If the smart key is easily accessible, keep it at least 16 feet (5
meters) away from the vehicle.
5. Disconnect the 12 Volt auxiliary battery under the deck board
and auxiliary box in the cargo area to prevent accidental
restarting of the vehicle.
Disconnect Charge Cable Connector Close Charge Inlet Door
Disconnect Plug
Shut Off Vehicle (READY-OFF)
Remove Deck Board and Auxiliary Box
12 V Auxiliary Battery
To Next Page
Loading...
Need help?
General
