TL-MR3220 3G/3.75G Wireless Lite N Router
-25-
)
Note:
The default PIN code of the Router can be found in its label or the QSS configuration screen as
Figure 4-2.
c). You will see the following screen when the new device successfully connected to the
network.
)
Note:
1) The status LED on the Router will light green all the time if the device has been
successfully added to the network.
2) The QSS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the QSS.
4.5 Network
Figure 4-4 the Network menu
There are five submenus under the Network menu (shown in Figure 4-4): Internet Access, 3G,
WAN, MAC Clone and LAN. Click any of them, and you will be able to configure the
corresponding function.
4.5.1 Internet Access
Choose menu “Network→Internet Access”, you can configure the access mode on the screen
below. The router is designed to work with either WAN port or 3G USB modem, and supports
automatically take over back up with 3G access as Ethernet WAN failover.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
