22
Chapter 4
Configure the Router in Wireless Router Mode
1 ) Select the RADVD address type to make the router assign IPv6 address prefixes
to hosts.
Note:
Do not select the Enable RDNSS and Enable ULA Prefix check boxes unless required by your ISP. Otherwise
you may not be able to access the IPv6 network. For more information about RDNSS and ULA Prefix, contact
our technical support.
2 ) Keep Site Prefix Type as the default value Delegated. If your ISP has provided a
specific IPv6 site prefix, select Static and enter the prefix.
3 ) Keep WAN Connection as the default value.
4. Click Save to make the settings effective.
4.3.3.2. Configure the DHCPv6 Server address type
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Network > LAN Settings page.
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select the DHCPv6 Server address type to make the router assign IPv6
addresses to hosts.
2 ) Specify the Start/End IPv6 Address for the IPv6 suffixes. The router will
generate IPv6 addresses within the specified range.
3 ) Keep Leased Time as the default value.
4 ) Keep Site Prefix Type as the default value Delegated. If your ISP has provided a
specific IPv6 site prefix, select Static and enter the prefix.
5 ) Keep WAN Connection as the default value.
4. 3. 4. MAC Clone
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.