2
About The Manual
Literature Change History
CG-SVP01B-EN (January 2005)
Original issue of this manual; provides specific program-
ming, diagnostic, and troubleshooting information CGAF
units with “K” and later design sequence.
Overview of Manual
Note: One copy of this document ships inside the
control panel of each unit and is customer
property. It must be retained by the unit’s
maintenance personnel.
These units are equipped with electronic control modules
which provides operating functions that are significantly dif-
ferent than conventional units.
The manual is divided into 6 sections. Each section pro-
vides the operator with specific information about the sys-
tem operating parameters and their related screens. By
carefully following the screen layout within this manual
while scrolling through the Human Interface, the operator
can monitor operating status, set specific operating param-
eters, and diagnose system problems.
Before attempting to operate or service this equipment, re-
fer to the “Start-Up” and “Test Mode” procedures in the ap-
plicable Installation, Operation and Maintenance manual,
listed on the unit nameplate.
Note: The procedures discussed in this manual
should only be performed by qualified, experienced
HVAC technicians.
Refer to the Table of Contents and Index for specific topics
contained in this manual and supporting manuals.
To Next Page
Loading...
Need help?
General
