RLC-SVX19A-E4
4
Introduction
Foreword
These instructions are given as a guide to good practice
in the installation, start-up, operation, and maintenance
by the user, of Trane RTAF chillers, manufactured in
France. A separate manual is available for the use and
maintenance of the unit’s control, Tracer™ UC800. They
do not contain full service procedures necessary for the
continued successful operation of this equipment. The
services of a qualifi ed technician should be employed
through the medium of a maintenance contract with a
reputable service company. Read this manual thoroughly
before unit start-up.
Units are assembled, pressure tested, dehydrated,
charged and run tested before shipment.
Warnings and Cautions
Warnings and Cautions appear at appropriate sections
throughout this manual. Your personal safety and the
proper operation of this machine require that you follow
them carefully. The constructor assumes no liability
for installations or servicing performed by unqualifi ed
personnel.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury. It may also be used to alert against unsafe
practices or for equipment or property-damage-only
accidents.
Safety Recommendations
To avoid death, injury, equipment or property damage,
the following recommendations should be observed
during maintenance and service visits:
1. The maximum allowable pressures for system leak
testing on low and high pressure side are given in
the chapter “Installation”. Always provide a pressure
regulator.
2. Disconnect the main power supply before any
servicing on the unit.
3. Service work on the refrigeration system and the
electrical system should be carried out only by qualifi ed
and experienced personnel.
Reception
On arrival, inspect the unit before signing the delivery
note.
Reception in France only:
In case of visible damage: The consignee (or the site
representative) must specify any damage on the delivery
note, legibly sign and date the delivery note, and the
truck driver must countersign it. The consignee (or the
site representative) must notify Trane Epinal Operations.
- Claims team and send a copy of the delivery note.
The customer (or the site representative) should send
a registered letter to the last carrier within 3 days of
delivery.
Note: For deliveries in France, even concealed damage
must be looked for at delivery and immediately treated
as visible damage.
Reception in all countries except France:
In case of concealed damage: The consignee (or the
site representative) must send a registered letter to the
last carrier within 7 days of delivery, claiming for the
described damage. A copy of this letter must be sent to
Trane Epinal Operations - Claims team.
Warranty
Warranty is based on the general terms and conditions
of the manufacturer. The warranty is void if the
equipment is repaired or modifi ed without the written
approval of the manufacturer, if the operating limits are
exceeded or if the control system or the electrical wiring
is modifi ed. Damage due to misuse, lack of maintenance
or failure to comply with the manufacturer’s instructions
or recommendations is not covered by the warranty
obligation. If the user does not conform to the rules of
this manual, it may entail cancellation of warranty and
liabilities by the manufacturer.
To Next Page
Loading...
Need help?
General