22 Wireless Sensors • BAS-SVX04C-EN
Installation
Configuring the Wireless Sensor (Model WDS only)
The configuration of the sensor determines which system features can be accessed and
changes can be made by the tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit features before configuring the
sensor.
The building owner or operator may choose to limit tenant access to certain features. This
can be done through configuration. Or, if a sensor is configured to match all control
capabilities of the building automation system, the locking feature can be used to restrict
the tenant from making changes.
Configuration Procedure
To configure settings on the model WDS sensor, follow this procedure in the order
presented.
1. Press the configuration button for 3 seconds.
The display will change to configuration mode. When the sensor is in configuration
mode, a wrench symbol appears on the display and the menus are separated by lines,
as illustrated below.
To Next Page
Loading...
Need help?
General
