Trane WZS User Manual

12 Wireless Sensors • BAS-SVX04C-EN
Pre-Installation
To set the receiver and sensor addresses:
1. Using a small screwdriver, set the three rotary address switches (locations S1, S2, S3)
on the receiver to an address between 001 and 999 (see Figure 1). (You do not have
to remove the covers to access the rotary address switches.)
Note: Do not use 000 as an address. An address of 000 returns the receiver outputs
to their factory defaults (zone temperature and setpoint outputs: 72.5°F
[22.5°C]), removes all association knowledge, and prevents association with a
sensor.
2. Set the three rotary address switches (locations S1, S2, S3) on the sensor to the same
address as the receiver (see Figure 1).
Note: Do not use 000 as an address. Add address of 000 removes all association
knowledge, reverts the sensor to a low-power hibernation mode, and sends a
disassociation request to the receiver.
3. Record the address and location of the receiver and sensor pair.
Figure 1. Setting the rotary address switches on the receiver and the sensor
S
5
GND
R77
C35
S1
S2
C33
LED4
S4
S5
S3
LED1
LED2
LED3
LED5
C34
J1
COMM -
24VAC/DC
SETPOINT
HEATING SET
SIGNAL
POWER
ADDDRESS
FAN/SYSTEM
ZONE
COMM +
IN
S
T
A
L
L
WIRELESS
GND
!
B1 +
INSTALL
WIRELESS
S4
S3
S2
S1
ADDRESS
STATUS
BATTERY
LED5
SIGNAL
LED3
L
E
D
2
LED1
Pb
Pb-FREE
STATUS
LED4
L
T
A
L
L
L
E
S
S
L
T
A
A
L
E
Do not remove the
insulation strip yet.

Trane WZS Specifications

General

Brand	Trane
Model	WZS
Category	Accessories
Language	English