18 Wireless Sensors • BAS-SVX04C-EN
Installation
Observing the Receiver for Readiness to Associate
After initial power up, the receiver conducts a channel scan for 20 seconds. During this
time, the receiver selects from 16 available channels the clearest channel on which to
operate. LED1, LED2, and LED3 flash rapidly in succession (round-robin style) while the
channel scan is in progress, as shown in part 1 of the illustration.
Important: Do not attempt association (leave the insulation strip in place) until the
channel scan is finished.
After the channel scan is finished, LED3 begins blinking (one-blink pattern) to show that
the receiver is ready to be associated with a sensor. See part 2 of the illustration.
2
1
LED3
0
20
Sec.
To Next Page
Loading...
Need help?
General
