GENERAL INFORMATION
116
Daily Safety Checks
Warning
Failure to perform these checks every
day before you ride may result in
serious motorcycle damage or an
accident causing serious injury or
death.
Check the following items each day
before you ride. The time required is
minimal, and these checks will help
ensure a safe, reliable ride.
If any irregularities are found during
these checks, refer to the Maintenance
and Adjustment section or see your
authorized Triumph dealer for the action
required to return the motorcycle to a
safe operating condition.
Check the following:
Fuel: Adequate supply in tank, no fuel
leaks (page101).
Engine Oil: Correct level on dipstick. Add
correct specification oil as required. No
leaks from the engine or oil cooler
(page140).
Drive Chain: Correct adjustment
(page150).
Tires/Wheels: Correct inflation
pressures (when cold). Tread depth/
wear, tire/wheel damage, punctures etc.
(page174).
Nuts, Bolts, Fasteners: Visually check
that steering and suspension
components, axles, and all controls are
properly tightened or fastened. Inspect
all areas for loose/damaged fasteners.
Steering Action: Smooth but not loose
from lock to lock. No binding of any of
the control cables (page162).
Brakes: Pull the brake lever and push
the brake pedal to check for correct
resistance. Investigate any lever/pedal
where the travel is excessive before
meeting resistance, or if either control
feels spongy in operation (page154).
Front Brake Pads: Check that the
correct amount of friction material is
remaining on all the brake pads
(page154).
Brake Fluid Levels: No brake fluid
leakage. Brake fluid levels must be
between the MAX and MIN marks on
both reservoirs (page157).
Front Forks: Smooth action. No leaks
from fork seals (page164).
Throttle: Make sure that the throttle
grip returns to the idle position without
sticking (page26).
Clutch: Smooth operation and correct
cable free play (page148).
Coolant: No coolant leakage. Check the
coolant level in the expansion tank
(when the engine is cold) (page145).
Electrical Equipment: All lights and the
horn function correctly (page185).
Engine Stop: Stop switch turns the
engine off (page118).
Stand: Returns to the fully up position
by spring tension. Return springs not
weak or damaged (page110).