MAINTENANCE
154
Front Brake Wear Inspection
Warning
If installing new proprietary brand
brake pads, check that the carrier
plate of the brake pad is the specified
thickness shown in the table.
Installing brake pads with the carrier
plate less than the specified thickness
may result in brake failure due to the
possible loss of the brake pad as it
wears.
Brake pads must be inspected in
accordance with scheduled
requirements and replaced if worn to, or
beyond the minimum service thickness.
1. Carrier plate
2. Brake pad
1. Carrier plate
2. Brake pad lining
Brake pads for this model supplied by
Triumph will have the carrier plate at
the recommended thickness. Always
have replacement brake pads supplied
and installed by your Triumph dealer.
If the lining thickness of any brake pad
is less than that specified in the table,
replace all the brake pads on the wheel.
Street Triple
RS
All Other
Models
Carrier Plate
Minimum
Thickness
0.19 in (4.8
mm)
0.16 in (4.0
mm)
Minimum
Brake Pad
Lining
Thickness
0.04 in (1.0
mm)
0.06 in (1.5
mm)
Minimum
Service
Thickness
(Brake Pad
Lining and
Carrier Plate)
0.23 in (5.8
mm)
0.21 in (5.5
mm)
To Next Page
Loading...
Need help?
General
