General Information
68
Center Stand (if equipped)
Caution
Do not use body panels or the seat
as a handhold when placing the
motorcycle on the center stand as this
will cause damage.
1. Center stand
To set the motorcycle on the center
stand, hold the motorcycle upright, step
down firmly on the foot finder part of
the stand, then lift the motorcycle up
and to the rear using the rear frame as
a handhold.
For instructions on safe parking, refer
to the How to Ride the Motorcycle
section.
Side Panels
All Models except Street Scrambler
citf
1
2
2
1. Side panel (right hand shown)
2. Grommets
The right side panel can be removed to
gain access to the adjustment tool and
the rear brake fluid reservoir.
To remove either side panel:
• Grasp the panel firmly and pull the
panel away from the motorcycle
until it is free from the three
retaining grommets (leaving the
grommets in place).
To reinstall either side panel:
• Position the three locating dowels to
the grommets, then press firmly to
secure the panel.
• Finally, grasp the panel and make
sure that it is fully retained.
To Next Page
Loading...
Need help?
General
