177
To check the oil level in the final drive
unit:
• Remove the filler level plug.
• Fill with 75W/90 fully synthetic
hypoid oil that meets specification
API Service Level GL5, such as
Castrol SAF-XO fully synthetic
hypoid oil, until the level of oil inside
the unit is level with the bottom of
the filler.
• Reinstall the plug and tighten to
18 lbf ft (25 Nm).
Brakes
Brake Wear Inspection
1
2
1. Brake pads
2. Minimum thickness line
Brake pads must be inspected in
accordance with scheduled
requirements and replaced if worn to, or
beyond the minimum service thickness.
If the lining thickness of any pad (front
or rear brakes) is less than 0.06 in
(1.5 mm), that is, if the pad has worn
down to the bottom of the grooves,
replace all the pads on the wheel.
To Next Page
Loading...
Need help?
General
