73
Trip Meters
OFF-ROAD
AUTO
OFF-ROAD
MPG
MI
PSI
PSI
CNS
1
2
36
42
F
R
47
12
1
2
1. Trip meter 1 display
2. Trip meter 2 display (if activated)
The home screen will permanently
display trip meter one as default, but
can be configured to display two trip
meters. For information on trip set up,
see page 75.
Trip Distance
The total trip distance traveled since
the trip meter was last reset to zero.
Trip Meter Reset
To reset either of the trip meters, from
the home screen select the trip meter to
be zeroed, then press and hold the
SCROLL button in either direction for
two seconds. After two seconds, all
items within the selected trip meter will
reset to zero.
Trip 2 can also be set to automatically
reset after an adjustable time delay of
between one and eight hours. See Trip
Setup on page
75.
Motorcycle Information
Warning
When the motorcycle is in motion, only
attempt to switch between the
information and trip meter display
modes or reset the trip meter under
the following conditions:
• At low speed
• In traffic-free areas
• On straight and level roads or
surfaces
• In good road and weather conditions.
Failure to observe this important
warning could lead to loss of
motorcycle control and an accident.
The motorcycle information display
shows the currently selected motorcycle
information item.
Note:
•
If TPMS is equipped, the tire
pressures display will be available
for selection.
•
The motorcycle information display
will automatically switch to the
Range to Empty display when the
low fuel warning light is illuminated.
To access the motorcycle information
menu:
• Press the SCROLL button until the
motorcycle information display is
selected.
• Press the SELECT button to enter
the motorcycle information menu.
To Next Page
Loading...
Need help?
General
