- 22 -
3.3.3 Loading Media in Peel-off Mode (Option)
1. Open the printer right side cover.
2. Please refer to section 3.3.1 step 3~9 for
loading media.
3. Using the front display panel to do the
calibration first and set the printer mode to
peeler mode.
Note:
Please calibrate the gap/black mark
sensor before loading media in peel-off
mode to avoid paper jam.
4. Open print head release lever and label
guide bar release lever to pull
approximately 650mm of label through the
front of the printer.
5. Remove several labels to leave liner.
6. Install the paper core onto the liner rewind
spindle. Open the peel-off roller release
lever.
To Next Page
Loading...
Need help?
General
