- 54 -
This item is used to set the warning for ribbon low. For
example, if setting value is 30m, when ribbon capacity was
lower than 30m, the will be shown in red.
This item is used to check print head status and to set the
settings for print head care.
This item is used to enable/disable the
print head clean warning. If enable this
feature, once print head has been
reached the setting mileage then the
warning icon will be shown on printer UI
for reminding user to clean the print
head. The default setting is disable.
This item is used to reset the print head
clean warning mileage after cleaned
print head.
This item is used to set the expected
mileage for reminding user to clean the
print head. You have to enable the “TPH
warning lock” for use. The default setting
is 1 km.
This feature is used to check the contact information for
tech support service
To Next Page
Loading...
Need help?
General
