UNI-T UT60E User Manual

input terminals of the Meter.
input terminals of the Meter.
Measurement Operation (7)
20
Model UT60B/C/E: OPERATING MANUAL
anode & black clip to cathode instead of using test leads as
mentioned above.
l To minimize the effect of capacitance stored in the test leads,
the test lead should be as short as possible. To measure a
small value of capacitance, use REL mode to remove the
leads capacitance. Remaining voltage, insulated impedance,
& dielectric absorption from the capacitor may cause the
measurement error.
l It takes a longer time when testing a high capacitor value, the
testing time is around 15 seconds in 100 F range.
l The LCD displays indicating the tested capacitor is
shorted or it exceeds the maximum range.
l When capacitance measurement has been completed,
disconnect the connection between the testing leads and the
circuit under test and remove the testing leads away from the
The measured value shows on the display.
The measurement range is from 10Hz to 10MHz. To measure
frequency, connect the Meter as follows:
1. Insert the red test lead into theHzV
terminal and the black
test lead into the
COM
terminal.
2. Set the rotary switch to Hz; frequency measurement (Hz) is
default or press Hz % to select Hz measurement mode.
3. Connect the test leads across with the object being measured.
G. Frequency Measurement
(see figure 9)
Note
l When frequency measurement has been completed,
disconnect the connection between the testing leads and the
circuit under test, and remove the testing leads away from the
(figure 9)

UNI-T UT60E Specifications

General

Backlight	Yes
Product type	Digital multimeter
Frequency range	0.01 - 10000 kHz
AC current range	0.4 - 10 A
AC voltage range	4 - 750 V
DC voltage range	0.4 - 1000 V
Dimensions (WxDxH)	85 x 177 x 40 mm
Battery voltage	9 V

Weight and Dimensions

Weight	320 g