UNI-T UT60E User Manual

40V
400V
1000V/~750V
mA
Range Signal Requirement Frequency Range
4V 1.0V 5Hz~10kHz
5.0 5Hz~20kHz
45V 45Hz~4kHz
420 45Hz~1.6kHz
45mA 5Hz~5kHz
Measurement Operation (8)
A
l
To obtain a stable reading when measuring input scope
30V rms frequency signal:
Set the rotary switch to V .
Then press Hz% to select Hz measurement mode to
obtain frequency value.
When input scope 30V rms, please follow the above
step 2. carrying out the measurement.
l When making frequency measurement at voltage or current
range, please mind the following signal requirement table:
4A 45Hz~1kHz
l
To obtain a stable reading when measuring input scope
30V rms frequency signal:
Set the rotary switch to V .
Then press Hz% to select % measurement mode to
obtain
duty cycle value.
When input scope 30V rms, please follow the above
step 2. carrying out the measurement.
H. Measuring Duty Cycle (See figure 9)
The duty cycle measurement range is: 0.1%~99.9%. To
measure duty cycle, do the following:
1. Set up the Meter to measure frequency.
2. To select duty cycle, press Hz % until the % symbol is shown
on the display.
3. Connect the test leads across with the object being measured.
The measured value shows on the display.
Note
l The LCD displays 000.0% indicating the input signal is high
or low level.
l When duty cycle measurement has been completed,
disconnect the connection between the testing leads and the
circuit under test, and remove the testing leads away from the
input terminals of the Meter.
21
Model UT60B/C/E: OPERATING MANUAL

UNI-T UT60E Specifications

General

Backlight	Yes
Product type	Digital multimeter
Frequency range	0.01 - 10000 kHz
AC current range	0.4 - 10 A
AC voltage range	4 - 750 V
DC voltage range	0.4 - 1000 V
Dimensions (WxDxH)	85 x 177 x 40 mm
Battery voltage	9 V

Weight and Dimensions

Weight	320 g